EZCAM's
main screen showing lift, velocity, acceleration, jerk and radius of
curvature for opening and closing sides of one lobe. Lift data is
automatically saved to disk for future reference. Green curve represents
base circle runout. One size inspection probe can be used for any cam
lobe. Program will mathematically correct final data for whatever size
engine follower is specified.
Shown are
two drop-down menus of keyboard command functions available from the main
graphic display screen.
TABULAR
RESULTS
Data from one cam lobe can be viewed in the form
of a table.
LIFT CURVE DEVIATION PLOTS
For comparing measured data with original design
target data, a lift curve deviation plot can be displayed. All base circle
runout has been removed prior to this comparison. Corrected, re-centered
data can then be viewed on screen, printed or saved to disk.
Complete tabular results for all motion
curves on each cam lobe.
Dialog for measuring all lobes on a
camshaft.
A polar plot showing measured deviation
versus design tolerances.
Green trace is the target lift.
Red trace is the tolerance limit.
Magenta trace is a magnified view
showing deviations of measured
lobe data compared to target data.
